MacMoto Series COMPLETE FAIRING KIT

• Replaces the OEM upper and side panels. Will mount to your OEM lower!

• Newly designed lower fits the OEM fairings!!!
• Mounts flawlessly to the OEM Middle Panels!!
• AMA Approved
• Retains 4L/4Qt fluid
• Thermal Protection Kit is highly recommended with each lower!

Product Description

This is a high quality one-piece lower. All lowers are AMA-approved enclosed belly pans and can hold 4L/4QT of oil. Our bodywork uses stock mounting points and most parts have drilling points clearly indicated on the bodywork. All mounting points are reinforced with carbon kevlar to provide exceptional strength - an industry first by OPP!

Installation or Technical Notes

• This lower will fit OEM bodywork.
• 6 Dzus Fasteners are required to attach this lower to the OPP Upper.

Fiberglass

• Fiberglass parts are made with iso-ester resin which is more flexible and durable than polyester resin.
• Finishes are smooth, pin-hole free and ready to sand and paint.

Carbon Fiber

• Read more about the importance of epoxy resin and carbon fiber in our article entitled Carbon Fiber 101.
• Carbon Fiber, Carbon Kevlar and Titanium Silver parts are made with epoxy resin which is highly flexible, has a clear finish and does not spider-crack. Epoxy resins are superior to polyester resins in every way.
• Only Carbon Fiber, Carbon Kevlar or Titanium Silver is used in our bodywork - we don't cheat by using hidden layers of fiberglass!

OPP Recommendations

• Thermal Protection Kit - Protect your lower from exhaust header heat discoloration! Our AMA-approved lowers don't have header cut-outs to vent heat. Don't let your carbon fiber or expensive paint job get ruined! Highly recommended!
• Dzus Fasteners - All bodywork requires Dzus Fasteners to connect the lowers to the uppers. Quick Release D-Ring fasteners direct from England! Recommended with purchase of lowers and uppers.
• Frame Sliders - Protect your bike and bodywork with easy-to-install frame sliders. Honda CBR1000RR owners, check out our no-drilling-required frame sliders from LighTech!!!
• Case Covers - Most racetracks require engine and clutch case covers. We also carry case covers in Carbon Fiber, Carbon Kevlar and Titanium Silver.

• Seat height same position as OEM seat.
• Better feedback from rear tire. Less Cushion,better feel.
• World Supersport Style Single Rider
• Utilizes SBK Foam Pad

Racing Solo Seat

• This part is a 1 piece racing solo seat
• Must be used with a foam pad. Click here to view our SBK foam pad.
• Allows rider to have a lower center of gravity, therefore increasing performance.
• Stock mounting points may be used for installation.
• Check out our Tail Lights too!

NOTE: Fiberglass

1. We use an iso ester resin which is flexible and durable.
2. All mounting points are generously reinforced with carbon Kevlar.
3. Finish is a smooth, pin-hole free surface.
4. Easy to sand, ready to paint, your painter will love you.

NOTE: Kevlar, Carbon, Titanium Fiber

1. We only use epoxy resin, this gives the product both a clear finish, and high flexibility. Unlike polyester resin, high quality epoxy resin does not spider crack.
2. Only Kevlar, Carbon, and Titanium is used in our products, 2-3 layers depending on the product type.