About the Product
CDT Elite Series Carbon Fiber by CDT is the lightest, strongest, most flexible and most beautiful carbon fiber available and is manufactured with the same raw materials, production processes and even personnel as MotoGP, World Superbike, Ducati Factory and Formula 1 bodywork.
CDT Carbon Fiber begins with pre-pregnated carbon fiber ("pre-preg carbon") which is carbon fiber fabric that is saturated with epoxy resin and must be carefully stored in sub-zero temperatures. Pre-preg carbon is stronger, lighter and more consistent than non-pre-preg carbon fabric (which has resin applied during the production process). To create bodywork, the pre-preg carbon is vacuum-bagged, autoclaved and clear-coated. The vacuum-bagging process uses suction to make the pre-preg carbon conform exactly to the shape of a part mould. The moulded part is placed in an autoclave (think of it as an industrial strength pressure cooker) and subjected to carefully calibrated heat and pressure to cure the part. The end result is a perfectly shaped carbon fiber part that uses an absolutely minimal amount of epoxy resin yet is superior to any other carbon fiber piece.
Finally, the part needs to be given a perfect finish. The part is magnetized, sprayed with clear-coat powder pellets and baked in oven. This causes the powder pellets to melt and penetrate the carbon fiber, allowing for a deep, smooth, pit-free, super-shiny finish. This kind of clear-coating process is used for parts like fine jewelry.
The bottom line: CDT Elite Series Carbon Fiber is the best quality carbon fiber on the market for motorcycle fairings.
Still not convinced?
Check out this video your of the CDT-R factory, showcasing the intricate manufacturing process that CDT-R uses to make the highest quality carbon fiber on the market.
This is a high quality case cover designed to fit over your existing engine/clutch/crank case cover. It is made with several layer of Carbon Kevlar (our toughest material) and a final layer of Carbon Fiber, Carbon Kevlar or Titanium Silver. Install this to prevent costly bike damage and to allow you to ride your bike away after a major spill.
Installation or Technical Notes
- Use our Heat Resistant Adhesive to attach your OPP case covers to your bike. Use approximately 1 tube per case cover.
- Installation is an overnight process.
- Installation Instructions:
- Clean the inside of the OPP cover and your motorcycle engine/clutch cover with a solvent.
- Apply a generous layer of Heat Resistant Adhesive to the inside of case cover.
- Mount the OPP case cover. Press on firmly and secure with duct tape.
- Allow to dry overnight in a warm area.