Show US Pricing Show Canadian Pricing
Please note:

Superbike Seat Foam Pad

by

OPP

Fits the following bikes
  • All bikes

WHOOPS!

Sorry, we no longer carry this product.

Your shopping cart

Item(s):
0
Total:
$0 US

Questions about this product?
E-mail us: [email protected]

Product Description

Item Summary

  • Includes enough material for 2 seats
  • Customer trims to size
  • Attach using 3M spray glue
  • 1/2 Inch high density
  • 27 inches (68.5cm) x 21 inches (53cm) approximately

About the Product

  • Includes enough material for 2 seats
  • Customer trims to size
  • Attach using 3M spray glue
  • 1/2 Inch high density
  • 27 inches (68.5cm) x 21 inches (53cm) approximately
  •  
  • Product Description
  • This is a high density foam used by professional racers. This is used in conjunction with our Solo Seat Racing tail sections. The stock seat and tail section is replaced by a one-piece tail section and a piece of seat foam. 1/2 Inch high density
  • The seat foam performs two functions. One, it is a *sticky* material so you can corner harder - you'd slide off a stock seat. Two, it provides a bit of cushioning rather than sitting on the bare tail section.
  • Don't be afraid to be creative either! You can cut the seat foam to any shape! You can also double up the foam to provide a bit more cushioning.
  • Rider's Trick: You can use the roll of seat foam as a seat support as well. A racing tail section may crack under the weight of a rider without a support underneath. You can roll some of the seat foam and stuff it under the tail section as a support before installation.
  • Installation or Technical Notes
  • Includes enough material for back support.
  • Comes as one sheet - customer trims to size.
  • Use a 3M spray glue to attach the foam to the tail section.
  • Usual seat sizing:
    • Seat pad 25" x 16"
    • Back support 25" x 5"
  • OPP Recommendations
  • Thermal Protection Kit - Protect your lower from exhaust header heat discoloration! Our AMA-approved lowers don't have header cut-outs to vent heat. Don't let your carbon fiber or expensive paint job get ruined! Highly recommended!
  • Dzus Fasteners - All bodywork requires Dzus Fasteners to connect the lowers to the uppers. Quick Release D-Ring fasteners direct from England! Recommended with purchase of lowers and uppers.
  • Frame Sliders - Protect your bike and bodywork with easy-to-install frame sliders. Honda CBR1000RR owners, check out our no-drilling-required frame sliders from LighTech!!!