This is a high density foam used by professional racers. This is used in conjunction with our Solo Seat Racing tail sections. The stock seat and tail section is replaced by a one-piece tail section and a piece of seat foam. 1/2 Inch high density

The seat foam performs two functions. One, it is a *sticky* material so you can corner harder - you'd slide off a stock seat. Two, it provides a bit of cushioning rather than sitting on the bare tail section.

Don't be afraid to be creative either! You can cut the seat foam to any shape! You can also double up the foam to provide a bit more cushioning.

Rider's Trick: You can use the roll of seat foam as a seat support as well. A racing tail section may crack under the weight of a rider without a support underneath. You can roll some of the seat foam and stuff it under the tail section as a support before installation.

Installation or Technical Notes

• Includes enough material for back support.
• Comes as one sheet - customer trims to size.
• Use a 3M spray glue to attach the foam to the tail section.
• Usual seat sizing:
• Seat pad 25" x 16"
• Back support 25" x 5"

OPP Recommendations

• Thermal Protection Kit - Protect your lower from exhaust header heat discoloration! Our AMA-approved lowers don't have header cut-outs to vent heat. Don't let your carbon fiber or expensive paint job get ruined! Highly recommended!
• Dzus Fasteners - All bodywork requires Dzus Fasteners to connect the lowers to the uppers. Quick Release D-Ring fasteners direct from England! Recommended with purchase of lowers and uppers.
• Frame Sliders - Protect your bike and bodywork with easy-to-install frame sliders. Honda CBR1000RR owners, check out our no-drilling-required frame sliders from LighTech!!!